Metamask Error: Unable to Swap ERC20 Tokens on UNISWAP

I’ve encountered an issue with my Metamask setup that’s preventing me from successfully swapping simple ERC20 tokens on the UNISWAP router. In this article, I’ll explain the error and provide potential solutions to solve it.

The Issue

After adding liquidity to a token pair, such as ERC20 tokens on UNISWAP, I’ve been receiving the following error:

Too little received

This error is occurring because Metamask is not sending enough tokens to complete the swap. As a result, the swap attempt fails.

Why Does This Happen?

When you add liquidity to a token pair on UNISWAP, your MetaMask account receives a certain amount of tokens as part of the initial liquidity addition process. However, this amount may not be sufficient to support the desired swap amount. In most cases, the default amount of tokens sent to complete the swap is around 1-2% of the token’s supply.

Potential Solutions

To resolve this issue, you can try the following solutions:

1. Increase the Initial Liquidity Amount

You can increase the initial liquidity amount by using the --liquidity option when adding liquidity on UNISWAP:

metamask add liquidity --liquidity 1000000 
Replace with your desired token supply

This will send more tokens to complete the swap, increasing the likelihood of a successful transaction.

2. Use the --swap Option

Alternatively, you can use the --swap option when adding liquidity on UNISWAP:

metamask add liquidity --swap --amount 1000000 
Replace with your desired token supply

This will send a larger amount of tokens to complete the swap.

3. Check the Token Supply

Make sure you’re using the correct token pair and its supply on UNISWAP. If you’ve swapped from a different pair or token, try adding liquidity again for that specific pair.

Additional Tips

• Make sure your MetaMask account has sufficient balance to support the swap amount.

• Keep an eye on the transaction details to ensure it’s successful.

• Be patient and try adding liquidity again if the initial attempt fails.

By following these solutions or tips, you should be able to resolve the “Too little received” error when swapping ERC20 tokens on UNISWAP.